DEECO metals

DIRECTIONS TO OUR Hillside, New Jersey office:

A. From Route 21 "McCarter Highway":
1. Take Route 21 South to the Route 22 West exit.
2. Follow directions below from point **.

B. From Garden State Parkway:
Coming from the South - Parkway North:
1. Garden State Parkway to exit 140 - 82 East - "Union - Route 22". 
2. Take Route 22 East and at second overpass make Right at Bloy St. Exit. 
3. Make second right (1/8 mile) which takes you over bridge (Route 22).
4. At stop sign make Left onto Bloy Street 
5. Follow directions from point * below.
Coming down from the North - Parkway South:
1. Garden State Parkway through Union Tolls to "Union" exit
2. Take Route 22 East and follow directions starting at line 2 above.

C. From Newark Airport:
From Newark Airport we are 5-8 minutes (5 miles)
1. Take Route 1&9 North to Route 22 West.
2. ** When in Hillside, make Right onto Bloy Street ("Taco Bell" is on the right hand corner).
3. * Follow Bloy Street though traffic light to next intersection - (Bloy Street actually dead ends into Cooper Alloys Industrial Complex)
4. Proceed straight and make a left into fenced area with parking lot. Warehouse is in front of you, around the left hand side of building is main entrance. (A land mark when coming up to intersection is a large sign with "COOPER ALLOYS", we are 100 yards ahead, Building 5 on the left).

D. From Interstate 78 East:
1. Get off at Exit 54 "Hillside".
2. Turn Right at top of ramp.
3. Turn Left at first traffic light ("Chestnut Ave").
4. Make first Right onto Ramsey Ave.
5. Follow Ramsey for about 1 mile - at Stop Sign make Right onto "Bloy Street".
6. Make Left into parking lot and look for our signs and Building 5.

5. From New York: 
Take Holland Tunnel to Route 1 & 9 South
Follow signs and get on Route 22 West.
Follow directions from point ** (section C, line 2 above).

back